Refer to User Guide to raise the
Headrest and unbuckle and loosen
Harness as shown.
INSTRUCTIONS:
Nextfit Shoulder Pad
Replacement Kit
IMPORTANT: Please also refer to the
instructions that came with your product.
Remove Newborn Insert (if being used) as shown.
Lift the Seat Back Panel as shown.
Unsnap Seat Bottom Panel 4a and pull forward 4b.
4
4b
Kit Includes:
1 set of Shoulder
Pads (Right and
Left)
1
2
3
IS0095E
WARNING: Avoid serious injury or death to your child.
Never use your NextFit car seat without shoulder pads
in place. You must read and understand the Shoulder Pad
Replacement Kit instructions and the instructions in the
User Guide. If you do not understand these instructions,
DO NOT attempt to replace the Shoulder Pads, STOP
and call Chicco at 1-877-424-4226.
4a
IMPORTANT Final Check! Make sure Shoulder Pads, Chest Clip, and Buckle
Tongues are oriented as shown. Check to make sure Harness Straps are flat and not
twisted when buckled! Check to make sure Buckle is inserted correctly through the
cutout in Seat Bottom Panel. Refer to User Guide if necessary.
WARNING: Avoid serious injury or death to your child. You must make sure that all harness components
and shoulder pads have been replaced correctly, so the seat can provide maximum crash protection. Pull
on adjuster strap and the shoulder straps of the harness and operate the harness after this replacement is
complete. Make sure all straps are properly routed and secured. Make sure Shoulder Pads, Chest Clip, and
Buckle Tongues are oriented and installed correctly. If you have a problem, retry these instructions provided
AND review your User Guide. If you still have problems, STOP, Do Not use the Car Seat, and call Chicco at
1-877-424-4226.
Check to make sure BOTH metal Harness Pins are
secured! The metal pins must be inserted fully and the
plastic Locks must be snapped upward to hold the metal
Harness Pins in place. Pull on straps to make sure they
have been properly secured.
13
Unbuckle Harness and Repeat Steps 1 thru 5 in
REVERSE order: 5) Unfold the softgoods on each side,
4) Re-fasten Seat Bottom, 3) Re-fasten Seat Back Panel,
2) Add Newborn Insert (if being used), 1) Lower Head-
rest if necessary. Refer to User Guide if necessary.
14
4
15
Flat Head
screwdriver
(not included)
Comentários a estes Manuais